Rinse aid system
2.Fill in the rinse aid up to the max
mark.
– A higher level adds more rinse
aid to the rinse cycle, reduces
water stains and produces a
better drying result.
5.
To save the settings,
Press for 3 seconds.
Max
11.3
Switch off the rinse aid
system
If
the rinse aid refill indicator bothers
you, for example if you use combined
detergents with a rinse aid
component, you can switch off the
rinse aid system.
3.
If rinse aid has overflowed, remove
it from the rinse container.
Tip:The function of the rinse aid is
limited
with combined detergents. If
you use rinse aid, you will usually
achieve better results.
Overflowing
rinse aid can lead to
excessive foam formation during
the rinse cycle.
4.
Close the lid of the rinse aid
reservoir.
1. press.
aThe
lid clicks into place audibly.
2.
To open the basic settings,
3 seconds
press.
11.2 Adjust the amount of rinse
aid
added
a
The display shows Hxx. a
The
display shows
If streaks or water stains remain on
the dishes, change the amount of rinse
aid added.
1. press.
.
3. Press repeatedly
until
the display shows the factory-set
value r04.
2.
To open the basic settings,
3 seconds
press.
4. Press repeatedly until the
display shows r00.
5.
To save the settings,
Press for 3 seconds.
aThe
display shows Hxx. a
The
display shows .
aThe rinse aid system is
switched off
switches on and the rinse aid refill
indicator is deactivated.
3. Press repeatedly
until
the display shows the factory-set
value r04.
4. Press repeatedly
until the
appropriate amount of rinse aid
has been added.
– A low stu rinse
cycle
and reduces Sc
Dishes.
fe gives that
he rinse
aid too
hlieren on the
29
To Next Page
Loading...
Need help?
General
