Rinse aid system
¡The water hardness level is 0 -
6 °dH. You can do without special
salt.
Additional
consumption of electricity
in kWh
0.05
The stated consumption values are
laboratory measurements according
to the currently valid standard and
determined using the Eco 50°
program and the factory-set water
hardness value of 13 - 16 °dH.
1. press.
2.To open the basic settings,
3 seconds
press.
a
The display shows Hxx. a
The
display shows .
3. Press
repeatedly until the
display shows H00.
4.
To save the settings,
Press for 3 seconds.
11 Rinse aid system
a
The softening system is equipped
switches on and the salt refill
indicator is deactivated.
11.1
Rinse aid
For
optimal drying results, use rinse
aid.
Only use rinse aid designed for
household dishwashers.
10.5
Regenerate the softening
system
In order to
maintain the trouble-free
function of the softening system, the
device regenerates the softening
system at regular intervals.
The softening system is regenerated
in all programs before the end of the
main rinse cycle. The running time and
consumption values increase, e.g. B.
Water and electricity.
Fill
in rinse aid
If
the rinse aid refill indicator lights
up, add rinse aid. Only use rinse aid
designed for household
dishwashers.
1.The tab
on the lid of the rinse aid
reservoir
press and lift.
Overview of the consumption values
when regenerating the
Softening system
2
Here
you will find an overview of the
maximum additional running time and
consumption values when regenerating
the softening system.
1
Regenerating the softening
system after x rinsing
corridors
6
Additional term
i
ten
n minute 6
Additional consumption
of
in liters
Water 5
28
To Next Page
Loading...
Need help?
General
