Siemens ST-H - Installation Location Requirements; Insufficient Air Supply

Installing/mounting
3.1 Basic safety notes
Transducers
Compact Operating Instructions, 01/2018, A5E43390688_AA
15
3.1.1
Installation location requirements
3.1.1.1
Insufficient air supply
WARNING
Insufficient air supply
The device may overheat if there is an insufficient supply of air.
• Install the device so that there is sufficient air supply in the room.
• Observe the maximum permissible ambient temperature. Refer to the information in the
section Technical data (Page 37).
CAUTION
Aggressive atmospheres
Damage to device through penetration of aggressive vapors.
• Ensure that the device is suitable for the application.
CAUTION
Direct sunlight
Device damage.
The device can overheat or materials become brittle due to UV exposure.
• Protect the device from direct sunlight.
• Make sure that the maximum permissible ambient temperature is not exceeded. Refer
to the information in Technical data (Page 37).
NOTICE
Strong vibrations
Damage to device.
• In installations with strong vibrations, mount the transmitter in a low vibration
environment.