Siemens TUTORbit POL945 - Burner and Temperature Sensor Parameters; Burner Status and Power Levels; Temperature Sensor Configuration

92
TUTORBIT
COSMOGAS
Continued on the next page
6 - USE
Parameter Description
Access
level
Adjustment
range
Default value
Custom
value
Burner 3 Cond. N/A
Installer
2 = Waiting; 9 = In operation; 13 = Fan in post-ventilation; 15 = Pump in post-circulation;
Burner 3 state N/A
Installer
0 = Waiting; 16 = Heat request;
Burner 3 err code Burner 3 error code. See the heat generator’s manual for diagnostics
Installer
?? = No burner; 255 = No error; See the heat generator’s manual for any other codes;
Burner 3 power Burner 3 power level
Installer Value Value
Burner 4 Cond. N/A
Installer
2 = Waiting; 9 = In operation; 13 = Fan in post-ventilation; 15 = Pump in post-circulation;
Burner 4 state N/A
Installer
0 = Waiting; 16 = Heat request;
Burner 4 err code Burner 4 error code. See the heat generator’s manual for diagnostics
Installer
?? = No burner; 255 = No error; See the heat generator’s manual for any other codes;
Burner 4 power Burner 4 power level
Installer Value Value
Spring outdoor temp N/A
Installer Value Value
Spring supply temp N/A
Installer Value Value
Winter supply temp. N/A
Installer Value Value
Hold off outdoor temp N/A
Installer Value Value
T Night reduction N/A
Installer Value Value
Outdoor temperature N/A
Installer Value Value
Mod 2 Modbus State Address readings of the modbus module 2. Visible only if Conguration>System>Modbus Enable=Yes.
Installer
Mod 3 Modbus State Address readings of the modbus module 3. Visible only if Conguration>System>Modbus Enable=Yes.
Installer
Mod 4 Modbus State Address readings of the modbus module 4. Visible only if Conguration>System>Modbus Enable=Yes.
Installer
Diagnostics
Installer
Sensor Temperature sensor settings
Installer
Water heater sensor General cascade temperature sensor
Installer
Manual Inactive = Automatic reception of the ohmic value; Active = Manual setting of the ohmic value using the next
parameter
Installer Value Value
Actual value Temperature read or temperature setting if Diagnostics>Sensor>Water Heater sensor>Manual=Active
Installer Value Value
Error Reading error
Installer Value Value
High limit Indication of an error when it exceeds a certain value
Installer Value Value