en Operating the appliance
20
Programme end during rinse
hold
- - - appears in the display panel and the
! Start/Reload button indicator light
flashes.
To end the programme:
1. Select 0 p Spin/Empty (if only
a drained cycle is required: set rpm
(spin speed) to - - -).
2. Select ! Start/Reload.
Programme end
End appears in the display panel.
If the x symbol also appears in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Note: Add less detergent for the next
washing cycle with the same load.
Removing laundry/switching
off the appliance
1. Open the washing machine door
and remove the laundry.
2. Turn the programme selector to Off.
Appliance is switched off.
3. Turn off the tap.
Not required for Aqua-Stop models.
Contents of package ~ Page 31
Notes
– Do not leave any items of laundry
in the drum. They may shrink in
the next wash or discolour
another item.
– Remove any foreign objects from
the drum and the rubber seal –
risk of rusting.
– Leave the washing machine door
and detergent drawer open so
that any residual water can dry
away.
– Always remove the washing.
– Always wait until the programme
ends, as the appliance could still
be locked. Switch the appliance
on and wait for the unlocking
device.
– If at the end of the programme
the display has gone out, the
energy saving mode is active. To
activate, select any button.
To Next Page
Loading...
