Siemens WS12K261HK - Setting the Signal

Setting the signal en
21
M Setting the signal
Setting the signal
1. Activate setting mode for the signal volume
turn to Off hold down the button and turn one
position to the right
Press and hold the button for approx. five
seconds until the display elements light up.
Setting mode is activated.


2. Set the volume for the button signals (depending on model)
press the button until the required volume is
reached
go to point
3. or
set to Off, which exits setting mode for the
signal volume

3. Set the volume for the information signals
rotate it one step to the
right
press the button until the required volume is
reached
set to Off, which exits setting
mode for the signal volume
