Positioning and connecting en
37
10.Add standard detergent to
dispenser II according
to manufacturer’s instructions for
light soiling.
Note: To prevent frothing, use only
half the recommended amount of
detergent. Do not use any woollens
or mild detergents.
11.Close the detergent drawer.
12.Select ! Start/Reload.
13.At the end of the programme set the
programme selector to Off.
Your washing machine is now ready to
use.
Transportation
Preparatory work
1. Turn off the tap.
2. Reduce the water pressure in the
supply hose. Cleaning and
maintenance – Clean the water inlet
filter ~ Page 24
3. Drain the remaining detergent
solution. Cleaning and maintenance
– Drain pump blocked ~ Page 23
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Installing transportation protection
devices:
1. Remove the covers and keep in a
safe place.
If required, use a screwdriver.
2. Insert all 4 sleeves.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
■ The transport locks must be
removed! ~ Page 32
■ To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the 0 p Spin/
Empty programme: (if only
a drained cycle is required: set rpm
(spin speed) to - - -).
To Next Page
Loading...
