Sigma 2-5 - Page 32

Operating Manual SIGMA 2-5, page 32 of 55
03/06
4.1.4 Knobs
The parameters are selected by turning the knobs.
The time values are changed by turning the left knob, the right knob is used for
changing the speed/RCF values.
4.2 Displays
The display consists of two areas:
The left area is the time display, the right one the speed/RCF display.
4.2.1 Speed/RCF (Relative Centrifugal Force)
Rotor dimensions and speed determine the RCF value. Entry of one value
automatically determines the other one.