Sigma EOX VIEW 1300 - EOX Assembly Instructions; Over Clamp Butler Mounting

EOX
®
Assembly I 29
6. Assembly
6.1 Over Clamp Butler
Mounting the EOX
®
VIEW 1300 on the Over Clamp Butler
− Set the EOX
®
VIEW 1300 in 11 o’clock position on the Over Clamp Butler
− Turn the EOX
®
VIEW 1300 to the right until it’s straigt.
− The EOX
®
VIEW 1300 is now mounted
Option: With an additional screw (2.5 mm Allen key) it‘s possible to lock the EOX
®
VIEW 1300 from the back side of
the Over Clamp Butler.
Mounting the Over Clamp Butler to the handlebar
− Wrap thick rubber pad (for 31.8 mm handlebar) or thin rubber pad (for 35 mm handlebar) around
the handlebar on the left side of the stem
− Loosen the clamping screw of the Over Clamp Butler (2.5 mm Allen key) and place the Butler on the
rubber pad.
− Align the EOX
®
VIEW 1300
− Tighten the screw (2.5 mm Allen key) with 0.5 Nm
Note: When using the 31.8 mm rubber pad it’s possible to adjust the height over the stem by turning
the rubber pad