Sigma EOX VIEW 1300 - Ribbon Butler Cable Routing

EOX
®
Assembly I 31
#1
#2
− Insert EW-EN100 in the intended opening.
− Slot #1 must point at the clamp.
− The button muss point at the opening on the top side
of the Ribbon Butler.
− Carefully, place the cable outlet #1 inside the
cable groove.
− Press down the EW-EN100 until it fits tightly inside
the intended opening.
− If a cable is used at port #2 guide
it around the pin.
− Guide all cables inside the
cable groove.
− Press them down a little to make the
tightly fit inside the groove.