SIGMATEK CCP 531 - Status and Error Messages: Application & Runtime; Application Loading, Saving, and Memory Errors; CPU Instruction and Floating Point Error Causes; Runtime Limit Exceeded Error Conditions

C-DIAS PROCESSOR MODULE CCP 531
Page 26 12.04.2017
46
APPL-LOAD-ERROR
An error has occurred while
loading the application.
47
APPL-SAVE-ERROR
An error has occurred while
attempting to save the application.
50
ACCESS-EXCEPTION-
ERROR
Read or write access of a restrict-
ed memory area. (I.e. writing to the
NULL pointer).
51
BOUND EXCEEDED
An exception error caused by
exceeding the memory limits
52
PRIVILEDGED INSTRUC-
TION
An unauthorized instruction for the
current CPU level was given. For
example, setting the segment
register.
53
FLOATING POINT ERROR
An error has occurred during a
floating-point operation.
60
DIAS-RISC-ERROR
Error from the Intelligent DIAS-
Master.
64
INTERNAL ERROR
An internal error has occurred, all
applications are stopped.
Restart; report error to Sigmatek.
65
FILE ERROR
An error has occurred during a file
operation.
66
DEBUG ASSERTION
FAILED
Internal error.
Restart; report error to Sigmatek.
67
REALTIME RUNTIME
The total duration of all real-time
objects exceeds the maximum
time; the time cannot be config-
ured.
2 ms for 386 CPUs
1 ms for all other CPUs
Starting from Version 1.1.7
68
BACKGROUND RUNTIME
The total time for all background
objects exceed the maximum time;
the time can be configured using
two system variables:
-BTRuntime: time remaining
-SWBTRuntime: pre-selected
value for the runtime counter
70
C-DIAS ERROR
An error occurred in connection
with a C-DIAS module.
Cause:
- The reason for this error is
documented in the log file
Solution:
- Depends on the cause
a