C-DIAS PROCESSOR MODULE CCP 621
27.03.2020 Page 31
While accessing a DIAS module,
an error has occurred.
Possible Causes:
- An attempt is made to access
a nonexistent DIAS module.
- DIAS bus error.
Solution:
- Check the DIAS bus
- Check the termination
resistors.
The operating system is currently
being reprogrammed.
The operating system has been
reinstalled.
The operating system cannot be
loaded; too little memory.
Boot loader message.
No operating system found in
RAM.
The boot loader is searching for
the operating system in RAM.
The operating system loaded
does not match the hardware
configuration.
The LASAL Module or project
cannot be loaded.
A general error has occurred while
loading the operating system.
An error has occurred in the
application memory (user heap).