Need help?Do you have a question about the Signode PRHR-34 and is the answer not in the manual?
Potential hazards from strap breakage due to improper operation or load corners.
Risk of severe eye injury or blindness from not wearing safety glasses with side shields.
Maintaining minimum air pressure for proper sealing and controlling strap tension.
Procedure for adjusting strap tension using the regulator and adjusting screw.
Common causes and remedies for insufficient strap tension during operation.
Troubleshooting reasons for failure in the sealing and strap cutoff cycle.
General| Model | PRHR-34 |
|---|---|
| Category | Packaging equipment |
| Strap Type | Steel |
| Strapping Material | Steel |
| Tension Adjustment | Manual |
| Power Source | Pneumatic |
| Strap Width | 3/4 inch |
| Strap Thickness | 0.025 to 0.031 inch |
| Sealing Method | Sealless joint |
To Next Page
