Silca MARKER 2000 - 6.1.2-a Attributes definition [F7]

Operating manual - English MARKER 2000
Copyright Silca 2002 17
Fig. 21
WARNING: the program gives activation of automatic formatting by default (AutoF = [x]); this function is therefore
always active. However, the operator may change two marking method parameters per string without compromising
or altering the automatic formatting function:
1) Bold or standard 2) font (6x8, 8x8 ...)
See ch 6.1.2-a "Attributes definition [F7]" for instructions on how to alter the two parameters.
The following illustrations show examples of marking for different numbers of texts:
The marking area is sub-divided into the number of sections corresponding to the number of texts to be
marked and the text for each line is positioned in the centre of its area.
6.1.2-a Attributes definition [F7]
M ARKING WITH CUSTOMIZED FORMATTING
Texts are customized for marking by setting different
parameters on the marking area, such as: type of
character, height of character, ratio, alignment etc.
To alter attributes, place the cursor on the line
concerned and press F7 to proceed.
(example: SILCA SpA).
The display shows the parameters which can be
altered:
Press the ENTER key to select the parameter to be
altered and use the arrow keys to scroll the
options:
Hgt. (height): min.1.0 mm - max.6.5 mm
Rat. (scale): min.0.2 - max 2
All. (alignment): -><- centred; ---> right; <--- left;
Bold: [ x ] bold [ ] normal
Font: there are 5 alternatives 6x8 8x8 8x14 8x16 12x14
(ch.4.5).
Press ESC to exit from the menu.
WARNING: as can be seen on the display, during this operation the field relating to “automatic formatting” is not
activated (AutoF [ ]) indicating that “customized marking” is being used (fig. 22). However, the operator may return at
any moment to automatic formatting of the text by placing the cursor in the “AutoF[x]” field (with the ENTER, TAB keys)
and entering an “x” (AutoF [x]).
Fig. 22
A
marking area 3
AAAAAAAAAA
AAAAAAAAAA
AAAAAAAAAA
AAAAAAAAAA
SILCA S.p.A
SILCA S.p.A
SILCA S.p.A
SILCA S.p.A
VIA PODGORA
VIA PODGORA
VITTORIO VENETO
VIA PODGORA
VITTORIO VENETO
1 lines 2 lines 3 lines 4 lines
(1 empty)
S1 = SILCA SpA
S2 = Via PODGORA 20
S3 = VITTORIO VENETO
S4 =
F7
Config. S
Hgt.=1.0 Rap.1.0
Ali.=-><- Bold=[ ]
Font=6x8
Enter
Esc
S1 = SILCA SpA
S2 = Via PODGORA 20
S3 = VITTORIO VENETO
S4 =
Zone = 1 : 1 Clamp = C1
Slide = 3 S = 1 O = 0
Dire. = Hor AutoF = [x]
Pcs.= 1 of 1