Operating manual - English MARKER 2000
Copyright Silca 2002 21
6.1.6 Glass slide customization [F2]
The program includes the possibility to define
customized glass slides.
Whenever the screen shows data for the model,
access can be gained, through key F2, to the glass
slide customization menu.
Press key F2 to show the data for the glass slide
setting.
WARNING: the first 16 glass slides have been set up by Silca
and cannot be altered.
Use the arrow keys to scroll the list of
glass slides.
Use the TAB key to move from one line to another.
Press ENTER to confirm the datum entered.
Use the CANC key to delete a glass slide.
WARNING: dimensions are expressed in hundredths of a millimetre.
When creating a glass slide the user must observe the minimum and maximum dimensions, which are:
Height: min. 10 - max 3500 (hundredths of a mm)
Width: min. 10 - max 5000 (hundredths of a mm)
Note: when a new glass slide has been set up, on leaving the function it is recognized by the machine
as the current glass slide.
6.1.7 Clamp configuration [F3]
Function enabled only with the optional clamp “A5”.
6.1.8 Counters [F4]
If a counter has been previously entered into the
model, press key F4 to gain immediate access to
the counter definition menu.
Consult Ch. 6.4.2 for further information on counter
parameters.
Zone = 1 : 1 Clamp = C1
Slide = 3 S = 1 O = 0
Dire. = Hor AutoF = [x]
Pcs.= 1 of 1
F2
SILCA glass slide
Glass slide N. =
Width =
Height =
Zone = 1 : 1 Clamp = A5
Slide = 3 S = 1 O = 0
Dire. = Hor AutoF = [x]
Pcs.= 1 of 1
Zone = 1 : 1 Clamp = C1
Slide = 3 S = 1 O = 0
Dire. = Hor AutoF = [x]
Pcs.= 1 of 1
F4
From = A001
To = A100
Att. = A001
Incr. = 1
F10
To Next Page
Loading...
