MARKER 2000 Operating manual - English
34 Copyright Silca 2002
Test 103 = Magnet
Take the clamp to the “tracking” position.
When ENTER key on the keyboard is pressed an
impulse is sent to the marking punch.
Test 104 = Laser
Take the head all the way up to the end of run on
the Y axis (inwards on the machine) and on the X
axis (to the left).
The laser is turned on by holding down ENTER
key on the keyboard.
To facilitate viewing the projection, place a piece
of white paper over the clamp.
If projection is not clearly visible, first check
that the disk is properly positioned over the
marking zone
.
Test 105 = Temperature
This test gives an approximate indication of the
temperature at the power point on the electronic
control circuit board.
Normal temperature varies from 20°C to 50°C. If
the reading goes beyond the safety limit (for
correct operation of the circuit board) an alarm
message is issued (ch.9.1 "Trouble shooting").
Test 106 = Digital outlets
Test foreseen for optional functions, not yet in
use.
Test 107 = Inlets 1
Test foreseen for optional functions, not yet in
use.
Test 108 = Inlets 2
Test foreseen for optional functions, not yet in
use.
104 = Laser
Press any key and
check emission
103 = Magnet
Move point to free
zone and press any
key
105 = Temperature
24 (Max.90)
106 = Digital outlets
107 = Inlets 1
108 = Inlets 2
To Next Page
Loading...
