ON
1 2 3
Controlled by switched mains
Non Latching Switch: the motor will latch immediately it receives a
momentary signal and continue to the pre set end position.
To stop the motor while it is running apply a short signal in the
opposite direction.
For vertical Blinds only. Use a non latching switch. Short pulses
will rotate the angle of the blind but if the switch is held depressed
for more than 1 second the motor will latch and the blind will run to
the fully open or fully closed position.
Non latching switch: The motor will only run when the signal is
present (switch depressed). Mainly used when the motor is
being controlled from an AV or BMS controller.
As on-off-off but with the manual/electrical option enabled for
use with a 5420 system.
As off-on-off but with the manual/electrical option enabled for
use with a 5420 system.
As on-on-off but with the manual/electrical option enabled for
use with a 5420 system.
Not applicable
off-off-off
on-on-off
off-off-on
on-off-on
off-on-on
on-on-on
Operational Mode
DIP Switch
Position
Controlled by low voltage switching (requires permanent mains supply)
or Radio
on-off-off
off-on-off
To Next Page
Loading...
