8 Group Control of Motors
8.1 Group Control via Mains
Motors can be connected in parallel when mains switching. 3 motors
maximum are recommended. If quantities above 3 motors in parallel
are required, a qualied electrician must be consulted to ensure that
the supply, wiring and switching is suitable for the electrical load.
For motors to all run in the same direction on command attention must
be paid to ensure that the connections to all motors are identical. If
a motor is specically required to operate in the reverse direction on
command the connections to pins 2 & 3 should be reversed on that
specic motor.
To Next Page
Loading...
