6.3 Programming by means of Radio Remote
Control SG 9940
The remote control has to be teached-in with the motor before
the programming of the end positions by means of the Radio Re-
mote Control System can be performed. This can be carried out
with the following steps. Please refer to the user manual which is
enclosed with every delivered remote control.
To do Signal
Step
1
2
3
4
5
6
Check if the DIP switch setting is correct
(Setting according to Chapter 5.8).
Disconnect power supply of the motor for 5
seconds and make sure that the motor will
have permanent power supply when
reconnected. Typically unplug power
lead from motor.
Reconnect to power supply and
simultaneously push programming
button 1 or 2.
Simultaneously press both buttons (1&2)
and hold depressed for > 6 seconds.
After 3 seconds motor will sound and the
light will flash. Do not release the buttons.
Wait until motor sounds and light flashes
for the second time. Motor is then in pro-
gramming mode for 3 minutes.
Use programming button 1 to drive the
system to the first end stop position.
Then press both buttons simultaneously
for 3 seconds. This end position is
then stored.
Use programming button 2 to drive the
system to the other end stop position.
Then press both buttons simultaneously
for 3 seconds. This end position is
then stored.
Acoustic Signal,
LED blinks
Acoustic Signal
and LED blinks
after 3 and 6 seconds
respectively
Acoustic Signal
and LED blinks 1 x
Acoustic Signal
and LED blinks 1 x
To Next Page
Loading...
