Silvercrest SBD 60 A1 - Product and Beer Keg Assembly; Preparing Product and Beer Keg; Connecting a Beer Keg

24 GB/IE
 Preparing product and beer
keg
NOTE: You can use the product exclusively
with standard 5 litre pressurized beer kegs:
– Standard 5 litre pressurized beer kegs are
equipped with a built-in CO
2
dispenser
at the correct pressure. Without the
CO
2
dispenser in the keg, the product
cannot dispense beer.
– Standard 5 litre pressurized beer kegs are
delivered with connecting parts that are
necessary to connect the beer keg [] to the
product. Without these connecting parts, the
product cannot dispense beer.
Assembling the disposable faucet
 The disposable faucet is not part of the
delivery. Assembling the disposable faucet
requires parts that are delivered with the
product and parts that are delivered with the
beer keg [] (Fig. B and D):
Disposable faucet/Required parts
Beer keg parts
 [] Keg adapter
 [] Keg connector
Product part
 [2] Extension pipe
 Remove the wrapping material from the beer
keg [].
 Between the wrapping material and the top
of the beer keg [], there is a plastic case
containing the following connecting parts:
– [] Keg adapter
– [] Pre-assembled keg connector
– [] Short pipe
 Pull the short pipe [], if any, out of the keg
connector []. Discard the short pipe (Fig. D).
 Push an extension pipe [2] into the keg
connector [] (Fig. D). Position the extension
pipe so that its outlet points downward.
 Inserting the keg connector [] into the keg
adapter [] (Fig. E):
– Push the handle on the keg adapter []
backwards.
– Push the pin on the keg connector []
through the keg adapter [].
– Push the handle on the keg adapter [] up.
 The disposable faucet is completely assembled.
Connecting a beer keg
NOTES:
 If the beer keg [] has been moved recently:
Let the beer rest before connecting the beer
keg to the product.
 Once the beer keg [] is opened, do not keep
the beer keg inside the product for more than
5 hours.
 Place the beer keg [] in the cooling
container []. Position the beer keg so that
the keg notch [] lines up with the container
notch [] (Fig. F).
 Position the assembled disposable faucet
so that the pin on the keg connector [] is
positioned over the bung hole [] and the
extension pipe [2] fits snugly into the container
notch [] (Fig. F).
 Push down the keg connector [] so that the
pin on the keg connector pierces through the
bung hole [].
NOTE: A small amount of beer squirts out of
the disposable faucet once the pin pierces the
bung hole.