SDBSB 3000 A1
■ 16
│
GB
│
IE
– If the steam control lamp medium
u lights up, a medium quantity of
steam is produced.
– If the steam control lamp low
i lights up, only a small quantity of
steam is produced.
As soon as the steam control lamp high
z/medium u/low i (depend-
ing on the setting) lights up constantly, you can start steam ironing.
5) Hold the steam iron in a vertical position and press the steam button
2 (see
fig. 10).
Fig. 10
6) Touch the fabric lightly with the soleplate 8 and steam it to remove creases.
7) Release the steam button
2 to stop producing steam.
Topping up the water
NOTE
► As soon as the water in the water tank
0 is too low, the water tank control
lamp w lights up red.
► The water tank control lamp
w goes out as soon as there is enough water
in the water tank
0.
1) Put the iron down on the stand
6 on the base station.
2) Refill the water as described in the section Filling the water tank.
To Next Page
Loading...
Need help?
General
