GB
│
IE
│
NI
│
CY
│
11 ■
SDGS 1630 A1
NOTE
► Use tap water in the appliance. If your tap water is hard, we recommend
that you mix it with distilled water. Otherwise, the appliance will accumu-
late limescale quickly.
Mix the tap water with distilled water in accordance with the following
table for optimal performance:
Water hardness
Ratio of distilled
water to mains
water
very soft/soft 0
medium 1: 1
hard 2: 1
very hard 3: 1
Information about the level of hardness of water in your area can be
obtained from your local water company.
► Never use water that contains additives (e.g. starch, perfumes, softening
agents) or condensation (e.g. from dryers, refrigerators, air conditioning
units or rain). These may contain organic or mineral residues that accumu-
late when exposed to heat and can cause noise, brown discolouration and
premature failure of the appliance.
1) Remove the mains plug from the power socket if connected.
2) Remove the water tank
t from the appliance base z by pulling it upwards
by the handle (fig. I), then turn the water tank t around.
3) Unscrew the lid and fill up the water tank
t (fig. J). The “MAX” mark indi-
cates the maximum filling level.
I J
To Next Page
Loading...
Need help?
General
