■ 14
│
GB
│
IE
│
NI
│
CY
SDGS 1630 A1
Accessories
NOTE
► Before using any accessory, carefully read the manufacturer's care instruc-
tions on the label of the piece of clothing you are treating. We also
recommend that you test the accessory on a discreet part of the fabric first.
► Before attaching an accessory to the steam head
1, ensure that it has
cooled down completely and that the appliance is no longer connected to
the power supply.
Fabric brush
With clothing made from thick fabrics, such as cotton, the supplied fabric brush p
works the steam deeper into the fibres.
1) Before you switch on the appliance, attach the fabric brush p to the steam
head 1. To do this, align the lower part of the fabric brush p with the lower
part of the steam head 1 (fig. R). Gently press the top of the fabric brush p
until it snaps onto the steam head 1. It will audibly click into place.
2) Switch the appliance on and slowly brush the section of the fabric from top to
bottom. Do not apply a lot of pressure (fig. S).
3) Switch the appliance off, remove the plug from the power socket and allow the
appliance to cool down completely.
4) Before you detach the fabric brush
p, disconnect the appliance from the
power supply and allow it to cool down. Press the release latch on the fabric
brush p and simultaneously pull it forward (fig. T).
T
R S
To Next Page
Loading...
Need help?
General
