Silvercrest SDGS 1630 A1 - Crease Tool; Protective Cover for Sensitive Fabrics; Protective Glove

GB
│
IE
│
NI
│
CY
│
15 ■
SDGS 1630 A1
Crease tool
The supplied crease tool a helps you to renew or create creases.
1) Before you switch on the appliance, fully attach the hook on the supplied
crease tool
a into the mount on the bottom of the steam head 1 (fig. U).
2) Press the handle to open the crease tool
a.
3) Place the clothing between the crease tool
a and the steam head 1 and let
go of the handle.
4) Switch the appliance on and start at the top of the clothing. Slowly move the
crease tool
a downward (fig. V).
5) Switch the appliance off, remove the plug from the power socket and allow the
appliance to cool down completely.
6) Detach the crease tool
a by pulling the hook of the crease tool a out of the
mount on the bottom of the steam head 1.
Protective cover for sensitive fabrics
You should use the supplied protective cover s to press sensitive fabrics, such
as silk or velour.
♦ Before you switch on the appliance, pull the protective cover
s fully over
the steam head 1.
Protective glove
Wear the protective glove d if, for instance, you are steam-ironing the sleeves of
an item of clothing and inserting your hands into the sleeves to stretch the fabric.
You can hold the steam head 1 close to the fabric without burning your hand.
U
V