67
GB
11. Turn the dial5 again briefly in the di-
rection of the symbol until steam
emerges. This removes milk residues
from inside the steam nozzle8.
12. Finally, set the dial5 to OFF.
13. Press the steam button 28 to disen-
gage it and switch back to the espresso
function.
- The three LEDS23,26,27 flash.
- The device cools down.
When the red LED23 and the espresso
LED26 light up continuously again, the de-
vice is ready to prepare espresso again.
Accelerating the cooling process
This cooling process takes a few minutes. If
you want to quickly prepare another espres-
so, you can speed up the cooling process by
drawing hot water from the device:
1. While the three LEDs23,26,27 are
flashing, turn the dial5 in the direction
of the symbol .
2. Press the espresso button 25. First
steam, then water escapes.
3. When the steam LED27 goes out, turn
the dial5 back to OFF.
When the red LED23 and the espresso
LED26 light up continuously again, the de-
vice is ready to prepare espresso again.
15. Cleaning
DANGER! Risk of electric
shock!
The espresso machine and the power
cable with mains plug7 must not be im-
mersed in water or other liquids.
DANGER! Risk of injury from
burning!
Many components and accessories of
the
espresso machine
become very hot
during operation. Allow them to cool
down before cleaning.
WARNING! Risk of material dam-
age!
Do not use any astringent or abrasive
cleaning agents.
NOTES:
• The following accessories can be
cleaned in the dishwasher or by hand:
- the coffee spoon with tamper9
- the filters1/2
- the spout of the steam nozzle8
- the drip grid14
- the drip tray12
• The following accessories can be
washed by hand with mild detergent:
- the water tank3
- the portafilter19
• If the accessories that come into contact
with water, espresso or milk have resi-
dues of detergent, the taste of the es-
presso will be negatively affected.
Therefore, rinse these parts thoroughly
with clean water if cleaning with deter-
gent is necessary.
__368614_Espresso_Rosa_B5.book Seite 67 Dienstag, 2. Februar 2021 3:34 15