Silvercrest SEM 1100 B3 - Preheating for First Use; Heating After Inactivity;First Use

GB
│
IE
│
NI
│
CY
│
11 ■
SEM 1100 B3
Heating after a long time of inactivity / during first use
If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank  with tap water.
2) Place either the large % or the small espresso sieve + in the sieve holder 1:
– Make sure that the small indentation on the large %or small espresso
sieve + is located above the indentation on the sieve holder 1 when
inserted.
– Then turn the large % or small espresso sieve + slightly to ensure it
cannot fall out.
NOTE
► Wait until the espresso sieve % +has cooled down before taking it out!
► In order to remove the espresso sieves % + from the sieve holder 1,
turn the inserted espresso sieve % + until the indentation on the espresso
sieve % + is located directly above the indentation on the sieve holder 1.
You can now remove the espresso sieve % +.