Silvercrest SEM 1100 B3 - Parts and Troubleshooting; Ordering Replacement Parts; Troubleshooting Espresso Flow

■ 20
│
GB
│
IE
│
NI
│
CY
SEM 1100 B3
Ordering replacement parts
You can order the following replacement parts for the product SEM 1100 B3:
▯ Descaler (125 ml)
Order the product via our service hotline (see section Service) or comfortably
on our web page under www.kompernass.com.
NOTE
► Have the IAN number of the appliance ready (can be found on the cover
of these operating instructions) when you place your order.
Troubleshooting
Malfunction Cause Solution
The espresso no longer
flows out.
• The espresso powder is too
moist and/or compressed
too tightly.
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder.
• No water in the water tank .
• Fill the water tank 
with water.
• The holes of the sieve holder
openings are blocked.
• Clean the sieve holder 1.
The espresso drips over
the edges of the sieve
holder 1, not from the
openings.
• The sieve holder 1 is not
correctly inserted.
• Insert the sieve holder 1
correctly.
• The sieve holder openings are
blocked.
• Clean the sieve holder 1.
• There are espresso powder
residues on the edges of the
sieve holder 1.
• Clean the espresso powder
residues from the edges of
the sieve holder 1.