GB
│
IE
│
NI
│
CY
│
21 ■
SEM 1100 B3
Malfunction Cause Solution
The espresso is cold.
• The appliance was not
preheated.
• Preheat the appliance.
• The green heating-up control
lamp has not yet glowed.
• Wait until the green
heating-up control
lamp lights up.
• The cups were not pre-warmed. • Pre-warm the cups.
The pump is unusually
noisy.
• The water tank is empty.
• Fill the water tank
with water.
The crema is too light
(the espresso runs out
of the sieve holder 1
quickly).
• Not enough espresso powder.
• Use more espresso
powder.
• The espresso powder is too
coarsely ground.
• Use only espresso
powder specially manu-
factured for espresso.
The crema is too dark
(the espresso runs out
of the sieve carrier 1
slowly).
• Too much espresso powder. • Use less espresso powder.
• The powder is too finely ground
or moist.
• Use only espresso
powder specially manu-
factured for espresso.
• The sieve is blocked. • Clean the sieve.
The milk does not froth.
• The milk is not cold enough.
• Use milk from the
refrigerator.
• The milk frother is dirty. • Clean the milk frother .
Disposal
Disposal of the appliance
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of the European WEEE
(Waste Electrical and Electronic Equipment) Directive 2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please comply with all applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product.
To Next Page
Loading...
