Silvercrest SEM 1100 B3 - Component Cleaning Procedures; Cleaning the Milk Frother

GB
│
IE
│
NI
│
CY
│
17 ■
SEM 1100 B3
Cleaning the milk frother
1) Place an empty container under the milk frother .
2) Immediately after use, turn the steam control  to the “+“ position and
allow the steam to escape for a few seconds.
3) Turn the steam control  off (as far as it will go in the direction “-“), switch
the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Pull the casing of the milk frother  off (Figure 1) and clean it thoroughly in
warm water.
6) Wipe the nozzle under the casing with a damp cloth. If necessary, add a little
mild detergent onto the cloth. After cleaning with detergent, always wipe off
with a cloth moistened with clean water. Ensure that there is no detergent
residue left on the nozzle.
7) Push the casing back onto the nozzle (Figure 1).
Figure 1