Silvercrest SFB 10.1 C3 User Manual

SilverCrest SFB 10.1 C3
English - 15
 DVD/CD/VCR:
the remote control sends the code “PLAY”.
 DSAT/CBL:
the remote control sends the code “CH+”.
 AMP:
the remote control sends the code “MUTE”.
 Other devices:
the remote control sends the code “CH+”.
4. If your device responds to the sent code by powering on or off or by
executing one of the above functions, press to stop the
search. At this point you are close to the correct code, but you may
not yet have found the one that matches completely, as the
automatic search had been stopped with a slight delay and further
codes have been sent.
During the automatic search, the remote control responds to the
and buttons only.
5. After you have pressed the button to stop searching you can
press the buttons to send the previous or next codes
manually. If your device responds again to a code, you have found
a suitable code. Press to exit the automatic search. The codes
are saved and the display reads “SUCCESS”.
6. Or press to exit the automatic search. This will not save any
codes.
7. After the remote control has finished transmitting the last available
code from the code list, the search will stop and after a few seconds
the start window appears.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Direct code input (CODE SET)
1. Press and hold the button for 3 seconds.
2. Press , select “CODE SETUP” and then press .
3. Press , select “CODE SET” and press to confirm.
The selected device flashes and the currently set device code
appears on the display. At this point you can select a different device
by using the device buttons. Confirm your selection with .
4. The first digit of the 4-digit device code currently set flashes.
5. Enter the correct 4-digit code for the device selected by using the
number buttons. You can find the 4-digit code in the device code list
supplied.
6. Press to confirm the entry. The display reads “SUCCESS”
followed by “CODE SET”.
7. Invalid CODES cannot be found in the CODE list. If you enter an
invalid code “NOT FOUND” appears on the display and you can
then enter the correct code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Flex mode
For the different device buttons there are preset code lists for specific
device groups. Normally, you will assign the corresponding device types

Silvercrest SFB 10.1 C3 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 C3
Category	Remote Control
Language	English