Silvercrest SFB 10.1 C3 User Manual

SilverCrest SFB 10.1 C3
English - 21
9. Repeat steps 5 to 8 for each button that you wish to learn a function.
10. If the transmission of the original code fails or no code is sent during
the next 30 seconds, “FAIL” appears on the display. In this case,
repeat steps 5 to 8.
You can quit learning mode by pressing the button if the display
reads “SELECT KEY”. Pressing any of the device buttons takes you back
to the start window.
If you experience any problems with the learn function, the
batteries of the original remote control could be low.
Replace them if necessary.
Deleting individual button codes (DELETE KEY)
This function allows you to delete the learned code for an individual
button for a selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the button for 3 seconds.
3. Press , select “LEARNING” and press to confirm.
4. Press , select “DELETE KEY” and press to confirm.
5. The display reads “SELECT KEY”.
6. Press the button for which you want to delete the code. The display
reads “SURE DELET”.
7. Press to confirm. The display reads “DELETED” and then again
“SELECT KEY”.
8. Repeat steps 6 and 7 for each button for which you wish to delete
the code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Deleting the device codes of an individual device (DELETE
DEV)
This function allows you to delete all learned codes for a selected device.
1. Press and hold the button for 3 seconds.
2. Press , select “LEARNING” and press to confirm.
3. Press , select “DELETE DEV” and press to confirm.
4. The display reads “SELECT DEV”.
5. Press the device button of the device for which you want to delete
the code. The display reads “SURE DELET”.
6. Press to confirm. The display reads “DELETED” and then again
“SELECT DEV”.
7. Repeat steps 5 and 6 for each device for which you wish to delete
the codes.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Deleting all button codes (DELETE ALL)
This function allows you to delete all learned codes for all devices at
once.
1. Press and hold the button for 3 seconds.
2. Press , select “LEARNING” and press to confirm.

Silvercrest SFB 10.1 C3 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 C3
Category	Remote Control
Language	English