Silvercrest SFB 10.1 C3 User Manual

SilverCrest SFB 10.1 C3
18 - English
Global volume adjustment (VOL THROUGH)
The global volume adjustment/mute feature allows you to assign the
volume adjustment of a device that does not have this feature (e.g. a DVD
player) to a different device (e.g. a TV). The advantage is that it is not
necessary to press a device button (in the above example, the TV device
button) first and then another device button to switch back to the
playback device (the DVD player in the above example).
Adjusting the global volume (VPT SETUP)
Switching on:
1. Press and hold the button for at least 3 seconds.
2. Press , select “CONFIGURE” and press to confirm.
3. Press , select “VOL THROUGH” and press to
confirm.
4. Press , select “VPT SETUP” and press to confirm.
The display reads “TO DEV”.
5. Next press the device button of the device that you want to assign
the volume control to, e.g. DVD. Then the display shows “FROM
DEV”.
6. Next, press the device button of the device from which you want to
use the volume control to, e.g. TV. Then the display will show
“SUCCESS” followed by “VOL THROUGH”.
After you have finished performing these steps, you can use the
and buttons to adjust the volume and also mute the sound of the TV
even while in DVD mode.
Disabling the global volume adjustment (CANCEL VPT)
Switching off:
1. Press and hold the button for at least 3 seconds.
2. Press , select “CONFIGURE” and press to confirm.
3. Press , select “VOL THROUGH” and press to
confirm.
4. Press , select “CANCEL VPT” and press to confirm.
The display briefly shows “SUCCESS” to confirm.
This cancels the global volume adjustment/mute function.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Global recording/playback control (PLAYBACK)
This function allows you to control a VCR, DVD player or Blu-ray player
with the recording / playback control buttons (5) without having to select
the corresponding device first by using the device buttons.
To use this function, a valid code for the desired device needs to be
assigned to the corresponding device button. This function is limited to the
, and device buttons. The default setting is “OFF”.
1. Press and hold the button for 3 seconds.
2. Press , select “CONFIGURE” and press to confirm.
3. Press , select “PLAYBACK” and press to confirm.

Silvercrest SFB 10.1 C3 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 C3
Category	Remote Control
Language	English