8
GB
7. Press the button|2 . The red LED|1
lights up. The film is being sealed.
- After approx. 5 - 7 seconds, the red
LED|1 goes out and the sealing pro-
cess is completed.
8. Simultaneously, press buttons|8 in order
to release the lock of the lid|11.
9. Open the lid|11 and remove the bag.
10.Check the welding seam. It should be a
smooth creaseless seam.
8.3 Vacuum-pack and seal
the bag
DANGER! Risk of electric
shock due to moisture!
~ For vacuum packing, no liquids must be
inside the bag.
~
Ensure that no liquid is sucked in during
the extraction of air. If this occurs, interrupt
the process by pressing the button|
3
.
1. Smooth the bag where it is to be
sealed.
2. Open the lid|11.
3. Figure A: place the bag in the device.
For this purpose, the end of the film
must be positioned shortly in front of the
rear limitation webs|12 and the lateral
limitation webs|15.
4. Ensure again that there are no creases
in the film - especially in the area above
the welding wire|14.
5. Close the lid|11.
6. Figure B: use both hands to press firm-
ly on the edges of the lid|11. They must
engage audibly.
7. Press the button|
4
. The green LED|
5
lights up. The vacuuming starts.
- After the vacuuming, the green LED|5
goes out and the red LED|1 lights up -
the sealing process is active. After ap-
prox. 5 - 7 seconds, the red LED|1
goes out and the sealing process is
completed.
8. Simultaneously, press buttons|8 in order
to release the lock of the lid|11.
9. Open the lid|11 and remove the bag.
10.Check the welding seam. It should be a
smooth creaseless seam.
9. Cleaning and
storage
DANGER! Risk of injury
through burning/scalding!
~ Allow the device to cool down com-
pletely before you clean it or put it
away.
~ The welding wire|14 becomes very hot
during operation. Do not touch the hot
welding wire|14.
DANGER! Risk of electric
shock!
~ Prior to cleaning, disconnect the mains
plug|6 of the device.
DANGER! Risk of electric
shock due to moisture!
~ The device, the power cable|6 and the
mains plug must not be immersed in
water or any other liquids.
WARNING! Risk of material
damage!
~ Do not use any astringent or abrasive
cleaning agents.
9.1 Cleaning
In order to ensure the proper function and
the full capacity of your device, clean it reg-
ularly.
• Wipe down the housing of the device
with a damp cloth.
• Prior to the next use, the device must be
completely dry.
__CPE281169_Folienschweissgeraet_B4.book Seite 8 Montag, 19. September 2016 3:02 15
To Next Page
Loading...
Need help?
General
