Silvercrest SFW200 - BT Music; Camera; Settings

19 GB/IE/NI
 Camera
This function allows you to
trigger the photo function
of your phone with your
smartwatch.
Smartwatch
NOTE: Make sure that the SilverCrest
Watch app is activated.
 Briefl y press the button
[1] to activate the
display
[2].
 Swipe left across the display
[2] to access the
mode overview.
 Swipe down across the display
[2].
 Tap on the camera icon.
 The connected mobile device counts down
from 3 and takes a photo.
 The photo is saved in the respective photo app
of your mobile device.
 Settings
This function allows you to
adjust various settings.
Smartwatch
 Briefl y press the button
[1] to activate the
display
[2].
 Swipe left across the display [2] to enter the
interface.
 Swipe down across the display
[2].
 Tap Settings to enter the sub menu.
Find phone
 Swipe across the display and tap on Find
phone. Your mobile device will vibrate and
emit an alarm so you can locate it.
Brightness
 Adjust the brightness of the display
[2].
Display off
 Set the length of time after which the display
[2] turns off .
NOTE: A longer period of time reduces the
battery capacity.
Dial switch
 Select your desired dial face (see “Customizing
watch face”).
Language
 Select the desired language.
Reset
 This function is used to reset the product to the
factory settings.
Shut Down
 Tap Shut Down to switch off the product.
System
 Swipe across the display
[2] and tap on
System to show the following information:
– Bluetooth MAC address
– Firmware version number
– Device name
Bluetooth
 If required, the Bluetooth function can be
switched on or off at any time.
 BT Music
This function allows you to
control various audio apps on
your mobile device.
Smartwatch
 Briefl y press the button
[1] to activate the
display
[2].
 Swipe left across the display
[2] to access the
mode overview.
 Swipe down across the display
[2].
 Tap BT Music.
 Start or pause audio playback.