Silvercrest SGR 150 B2 - Initial Operation

SGR 150 B2
GB
│
MT
│
61 ■
Initial operation
WARNING! RISK OF INJURY!
► Always switch off the appliance and remove the mains plug from the mains
socket before assembling or disassembling the appliance and fitting or
changing accessories. Wait until the motor stops completely.
► Do not connect the appliance to the mains until it has been completely
assembled.
► Be careful when handling the drums 2 3 4 5 0.
The blades are very sharp!
♦ Before first use, clean all parts of the appliance as described in the section
Cleaning.
♦ Pull the power cable fully out of the cable storage compartment 7.
♦ Set up the appliance on a level, dry and non-slip surface.
♦ Fit the drum housing 9:
– Insert the drum housing 9 so that the arrow▸ on the drum housing 9
points to the open lock symbol
on the appliance.
– Turn the drum housing 9 anticlockwise so that the feed tube q points
upwards and the arrow ► on the drum housing9 points to the closed
lock symbol
on the appliance. The drum housing9 engages
noticeably.
– Insert the pusher w into the feed tube q.
♦ Insert a drum 2 3 4 5 0 into the drum housing 9, as described in the
section Inserting/removing a drum.
♦ Carefully stack the remaining drums in the storage container6 and close
the lid 1. Slide the storage container 6 from above onto the locking
device at the rear end of the appliance.
♦ Insert the plug into a suitable mains socket.
The appliance is now ready for use.