Silvercrest SHAZ 22.2 E6 - Charging the Rechargeable Battery; Meaning of the Rechargeable Battery Control Display

36 GB/IE
Charging the rechargeable
battery
Note: Charge the rechargeable battery
2
fully
(approx. 4 to 5 hours) prior to first use.
Hang up the main unit
4
with
aluminium suction tube
15
to
charge on the wall bracket
5
or
place it out of the reach of children
and pets in a protected location
where no one can trip over or
step on the main unit
4
with
aluminium suction tube or the
mains cable.
Insert the connection plug of the mains cable
9
into the charging socket
3
on the rechargeable
battery
2
(see Fig. D).
Insert the mains adapter
8
into the mains
socket. The LEDs on the rechargeable battery
control display
2b
show the charge level of the
rechargeable battery
2
(see chapter “Mean-
ing of the rechargeable battery control display”).
Note: During the charging process, the mains
adapter
8
may warm up. This is normal and
does not indicate that the product is defective.
Remove the mains adapter
8
from the mains
socket and the mains cable connector plug
9
from the charging socket
3
when the recharge-
able battery
2
is fully charged. The LEDs on the
rechargeable battery control display
2b
go out.
Charging the rechargeable battery
outside of the main unit:
Charge the rechargeable battery
2
in a protected location and
outside the reach of children
and pets.
You can remove the rechargeable battery
2
to charge it outside of the main unit
4
. Press
the release button
2a
and pull the rechargeable
battery
2
out of the holder on the handle
1
of the main unit
4
(see Fig. E).
Insert the mains cable connector plug
9
into
the charging socket
3
of the rechargeable
battery
2
(see Fig. F).
Insert the mains adapter
8
into the mains
socket. The LEDs on the rechargeable battery
control display
2b
show the charge level of the
rechargeable battery
2
(see chapter “Mean-
ing of the rechargeable battery control display”).
Once the rechargeable battery
2
is fully
charged, the LEDs on the rechargeable battery
control display
2b
light up continuously.
Remove the mains adapter
8
from the mains
socket and the mains cable connector plug
9
from the charging socket
3
of the rechargeable
battery
2
. The LEDs on the rechargeable bat-
tery control display
2b
go out.
Put the charged rechargeable battery
2
back
in the main unit
4
by pushing it into the holder
in the handle
1
of the main unit
4
until it
locks into place.
Meaning of the rechargeable
battery control display
The 4 LEDs on the rechargeable battery control dis-
play
2b
show the charge level of the rechargeable
battery
2
.
Display in operation:
- When the rechargeable battery
2
is fully
charged, the LEDs on the rechargeable battery
control display
2b
light up continuously.
- If the LEDs go out during operation, this shows
that the rechargeable battery
2
is gradually
running out of charge.
- The rechargeable battery
2
is almost com-
pletely out of charge when only one LED is
illuminated.
Charge the rechargeable battery
2
immedi-
ately. The main unit
4
automatically switches
off when the level of charge in the rechargeable
battery is too low for continued operation.
Display during the charging process:
- The lit LEDs show the charging progress (already
charged proportion).