■ 8
│
GB
│
IE
│
NI
SHBR 560 A1
NOTE
► If you want to remove the hand element
1 from the appliance, you must
first remove the fresh water tank q from the appliance to reach the catch
of the hand element 1 (see section Filling the fresh water tank). Once
you have removed the fresh water tank
q, press the catch on the hand
element 1 out of the catch opening with a pointed object. You can then
pull the hand element 1 back out of the appliance (see fig. 2).
Ƈ Wind the power cable
u completely around the upper and lower cable
retainers z/p (see fig. 3).
Fig. 3
Ƈ The parking and cleaning station consists of a storage tray
4 and a rotary
brush holder 5 (see fig. 4). To assemble the parking and cleaning station, slide
the rotary brush holder 5 sideways into the opening on the storage tray 4.
Slide the rotary brush holder 5 downwards until it audibly engages in the
opening and is firmly attached to the storage tray 4 (see fig. 5).
+
Fig. 4 Fig. 5
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 8 09.06.2020 14:04:53
To Next Page
Loading...
