GB
│
IE
│
NI
│
13 ■
SHBR 560 A1
Fig. 16 Fig. 17
Ƈ Before each use, press and hold the cleaning solution switch
t for about
10 seconds to add cleaning solution to the rotary brush
6 so that it is ready
for use (see fig. 18). The cleaning solution display w flashes alternately
blue when the cleaning solution switch
t is held down (see fig. 19).
Fig. 18 Fig. 19
Ƈ Hold down the cleaning solution switch
t during both forward and back-
ward cleaning movements with the appliance. This ensures that the cleaning
solution is applied evenly to the carpet via the rotary brush.
NOTE
► When cleaning carpets, if you activate the cleaning solution switch
t,
twice as much cleaning solution is applied to the rotary brush 6 as during
hard floor cleaning.
► To allow carpets to dry more quickly after cleaning, move the appliance
several times over the carpet without holding down the cleaning solution
switch t.
Ƈ Press the carpet switch
e again to switch the appliance off (see fig. 17).
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 13 09.06.2020 14:04:55
To Next Page
Loading...
