Silvercrest SHBR 560 A1 - Page 19

■ 16
│
GB
│
IE
│
NI
SHBR 560 A1
Ƈ If necessary, clean the opening in which the waste water tank 2 is located on
the appliance with a damp cloth or rag (see fig. 26).
Fig. 26
Ƈ Allow the dirt filter
0, the waste water tank 2 and the lid of the waste water
tank 9 to dry completely (see fig. 27).
Ƈ Once the parts are fully dry, replace the dirt filter
0 back in the lid of the waste
water tank 9 (see fig. 28).
Fig. 27 Fig. 28
Ƈ Place the lid of the waste water tank
9 back onto the waste water tank 2
(see fig. 29).
Ƈ Fit the waste water tank
2 back onto the appliance by inserting the bottom
of the waste water tank 2 first. Then push the waste water tank 2 into the
appliance until the waste water tank 2 audibly clicks into place (see fig. 30).
IB_329835_SHBR560A1_LB6_GB-IE-NI.indb 16 09.06.2020 14:04:55