Silvercrest SHBS 500 E4 - Fitting and Removing Comb Attachments; Attaching Comb Accessories

GB│IE
│
13 ■SHBS 500 E4
Fitting/removing the comb attachments
WARNING!
► Never use the appliance with a defective or broken comb attach-
ment
0/q. Missing teeth on the comb attachment 0/q could
cause injuries.
► Switch off the appliance before fitting or removing a comb attach-
ment 0/q.
♦ To fit a comb attachment
0/q push it onto the appliance below
the shaving head 1. Make sure it slides into the guide rails 3
on the left and right side of the appliance. Then push the comb
attachment 0/q along the guide rails 3 and slide it downwards
(see fig. 2). While doing so, keep the button on the rear of the comb
attachment 0/q pressed in.
1
2
Fig. 2