GB│IE
│
17 ■SHBS 500 E4
Cutting contours and beard trimming
WARNING!
The cutting blade of the shaving head
1 is sharp. Handle it carefully
and never touch the cutting blade with your fingers.
Note
► Only cut dry hair with the appliance.
► Depending on the cutting angle, the cutting length can vary from the
setting on the comb attachment 0/q.
► Make sure that the comb attachment 0/q sits firmly on the shav-
ing head
1 after adjustment.
♦ Set the cutting length to the desired hair length on the comb attach-
ment
0/q. To do this, press the button on the back of the comb
attachment 0/q and push the comb attachment 0/q upwards
or downwards (see fig. 3). You can read the cutting lengths via the
markings on the comb attachment 0/q (see fig. 4). Now trim
your beard in stages.
Note
Press the upper side of the button, when you push the comb attachment
0/q upwards or downwards (see fig. 5). This makes it easier to
release the comb attachment 0/q from the catch and move it.
♦ You can use the appliance without the comb attachment
0/q (i.e.
with only the shaving head 1) to cut your hair very short or to cut
your beard and contours. In this way, you can cut the hair evenly
down to 1–2 mm.
To Next Page
Loading...
