■ 20
│
GB│IE SHBS 500 E4
6) Guide the nose of the shaving head 1 under the rear edge of the
housing. Press the shaving head 1 down into the notch and then
tip it forward until it audibly engages in the appliance (see fig. 10).
Fig. 10
Storage
♦ Store the appliance in a dust-free and dry location.
♦ When storing the appliance, fit one of the comb attachments
0/q
to the shaving head 1 to protect the cutting blade.
Troubleshooting
The following table will help you locate and correct any problems:
Fault Possible cause Remedy
The appliance
will not switch
on.
The battery is empty.
Connect the appliance
to a mains power socket
(see section Charging the
appliance).
To Next Page
Loading...
