Silvercrest SHBS 500 E4 - Disposal; Appliance Disposal Requirements; Packaging Material Disposal

GB│IE
│
21 ■SHBS 500 E4
Fault Possible cause Remedy
The cutting blade
of the shaving
head
1 is
labouring/not
moving freely.
The shaving head
1
is dirty and/or the
cutting blade is not
sufficiently oiled.
Clean the shaving head
1 and oil the cutting
blade (see section Clean-
ing the shaving head
and oiling the cutting
blade).
Note
► If you cannot solve the problem with the solutions given above,
please contact the Service Hotline (see section Service).
Disposal
Applies only to France:
The product, its packaging and the operating instructions are recycla-
ble. They are subject to an extended manufacturer responsibility and
will be collected separately.