Silvercrest SHF 1800 A2 - Operation; 11.1 Power connection; 11.2 The touch display; 11.3 Switching on;off

97
GB
11. Operation
DANGER of burns !
~ During operation, the surfaces of the de-
vice may become hot. Do not touch any
hot parts of the device such as the air
outlet21 on the back or the inspection
window6.
~ Use the handle11 to lift out the hot ro-
tating basket12 / rotary spit10.
~ Use oven gloves or potholders to touch
the hot accessories.
~ During frying, hot steam escapes from
the air outlet21. Be careful not to put
your hands into the steam.
~ Do not move or transport the hot air fry-
er1 while it is switched on.
11.1 Power connection
• When the device1 has been installed
for the desired purpose, insert the mains
plug20 into an earthed wall socket
which corresponds to the specifications
on the rating plate. The wall socket must
also be easy to reach after switching on
the device.
- All indications in the display2 light
up briefly.
- An acoustic signal is heard.
- Then the symbol for the Start/Stop
button31 will light up. The device is
in standby mode.
11.2 The touch display
On the touch display2 there are symbols
that only display certain functions, e.g. the
hot air symbol 23.
Other symbols (also) represent a button, e.g.
the Start/Stop button 31. The term ‘but-
tons’ is used in this instructions for buttons
and keys to make the text easier to read.
11.3 Switching on/off
• Press the Start/Stop button 31 in or-
der to switch on the device1 from
standby.
- The symbols in the display2 are
shown.
- The set temperature and cooking time
are displayed alternately.
• Press the Start/Stop button 31 again
in order to start the device1 with the se-
lected settings or the selected program.
- The hot air symbol 23 flashes.
- The set temperature and cooking time
are displayed alternately.
- The cooking time is counted down.
- If necessary, the program symbol33
is displayed.
• If you want to stop the process while the
device1 is running, press the Start/
Stop button 31.
- The display2 shows OFF.
- The fan continues to run and the hot
air symbol 23 flashes.
- After approx. 20 seconds the fan will
stop and 5 signal tones are heard.
The device1 is in standby mode.
Only the symbol 31 can be seen
in the display2.
Quick start function
After you have selected a program or car-
ried out manual settings, the device1 will
start automatically approx. 5 seconds after
the last entry.
__351606_2007_B5.book Seite 97 Montag, 7. Dezember 2020 3:16 15