EasyManua.ls Logo

Silvercrest SHFD 1500 A2 - Electrical Safety Precautions

Silvercrest SHFD 1500 A2
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 GB
Electrical safety
m DANGER! Risk of electric
shock! Do not attempt
to repair the product
yourself. In case of
malfunction, repairs
are to be conducted
by qualified personnel
only.
m WARNING! Risk of
electric shock! Do not
immerse the product in
water or other liquids.
Do not hold the product
under running water.
m WARNING! Risk of
electric shock! Never
use a damaged product.
Disconnect the product
from the power supply
and consult your
retailer if the product is
damaged.
m WARNING! Risk of
electric shock! Do not set
up the product next to a
sink or in moist areas.
Before connecting the product
to the power supply, check
that the voltage and current
rating corresponds with the
power supply details shown
on the product’s rating label.
Connect the product only
to an earthed wall socket.
Always make sure that the
plug is inserted into the wall
socket properly.
To avoid damaging the power
cord, do not squeeze, bend or
chafe it on sharp edges. Keep
it away from hot surfaces and
open flames as well.
Lay out the power cord in such
a way that no unintentional
pulling or tripping over is
possible.
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons
in order to avoid a hazard.
Pull the plug and not the cable
itself to disconnect the product
from the power supply.

Table of Contents

Related product manuals