10
SKD 2300 B2
GB
IE
Before initial use
■ Remove all packaging materials and all transport locks from the appliance.
NOTE
►
You may notice a slight smell when using the appliance for the first time.
This is normal and is completely harmless.
Electrical connection
To ensure safe and trouble-free operation of the appliance after making the
electrical connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage
and frequency) on the rating plate with that of your mains power supply.
These data must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over
hot surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
Inserting the batteries in the remote control
If the battery in the remote control
25
is dead, a new CR2032 battery needs to
be inserted.
♦ Open the battery compartment
30
on the underside of the remote control
25
.
(see description on the rear of the remote control
25
)
♦ Remove the old battery from the remote control
25
.
NOTE
► Please follow the disposal instructions (see section Disposal of batteries).
♦ Insert a new CR2032 battery into the battery compartment
30
.
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment
30
back into the remote control
25
.
To Next Page
Loading...
