Silvercrest SKD 2300 B2 - Advanced Heating Functions; Setting Heating Timer; Overheating Protection Mechanism; Frost Protection Functionality

15
SKD 2300 B2
GB
IE
Set heating time
The appliance has a timer that you can use to set the desired heating time between
1 to 24 hours. Once this period is over, the appliance switches off automatically.
♦ Press the timer button
17
or until the desired runtime
18
is shown on the
display
2
.
♦ To switch the timer off, press the timer button
17
or repeatedly until no
runtime
18
appears on the display
2
.
Overheating protection
The appliance is fitted with a thermostat-controlled overheating protector. If the
appliance becomes too hot internally, the heating element switches off automati-
cally. As soon as the appliance has cooled down, the heating element switches
back on.
WARNING
As a general rule, there is a reason for overheating! It can
mean a risk of fire!
► Check that the appliance can sufficiently dissipate the heat generated: Is
the appliance covered or is it too close to a wall or other obstacle? Is the
fan blocked?
► Check that neither the air inlet
5
nor the air outlet
3
is blocked and
remove the cause.
► If possible, eliminate the problem or contact the Service Hotline (see the
chapter Service).
► Even if you cannot find a cause, but the overheating protection triggers a
second time, you must return the appliance to Customer Services for inspec-
tion or repair.
Frost protection function
The appliance has a frost protection function that prevents the room temperature
from falling below the frost line.
♦ Press the button for selecting the heat setting
24
or
26
repeatedly until the
"Frost protection" symbol
12
appears on the display
2
.
NOTE
► As soon as the temperature in the immediate vicinity of the appliance
falls under 5°C (41°F) the appliance will switch on automatically.
► As soon as the temperature climbs above 9°C (48°F), the appliance
switches itself off and the room temperature will be shown on the
display
2
.
♦ To switch off the frost protection function, press the button for selecting the heat
setting
24
or
26
repeatedly until the "Frost protection" symbol
12
disappears
from the display
2
.