14
SKD 2300 B2
GB
IE
Selecting the temperature
NOTE
► The display
2
shows the set target temperature
19
and measured actual
temperature
20
.
► The temperature measurement is made by the temperature sensor
7
. It
may take some time until the whole room has reached this temperature.
♦ Press the button
23
or
28
to select the unit of measure, to select whether the
temperature display uses °C or °F.
The selected unit of measurement
13
is shown on the display
2
.
♦ Press the "Increase temperature" button,
15
or
32
, to increase the target
temperature
19
up to a maximum of 37°C (99°F).
The selected target temperature
19
is shown on the display
2
.
♦ Press the "Decrease temperature" button,
16
or
29
, to decrease the target
temperature
19
down to a minimum of 5°C (41°F).
The selected target temperature
19
is shown on the display
2
.
Select heat setting
The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■ Level 1: 1000 watts
■ Level 2: 1300 watts
■ Level 3: 2300 watts
♦ Press the button to select the heat setting
24
or
26
repeatedly until the
desired heat setting has been set.
The selected heat setting
10
is shown on the display
2
.
Switching on the fan
The appliance has a fan which can be used to distribute heated air throughout
the room more quickly.
♦ Press the fan button
14
or
27
to switch the fan on or off.
If the fan is running, the "Fan" symbol
11
appears on the display
2
.
NOTE
► If the fan is switched off, the heat is concentrated more around the appli-
ance and is not distributed so quickly around the room.
To Next Page
Loading...
