■ 16
│
GB
│
IE
│
NI
SKR 800 B2
Receiving stations in mono
♦ If you would like to receive a station in mono, press and hold the | ST/
MO button
for about 2seconds until ST (for stereo display) disappears
from the display
.
NOTE
► ST is only displayed if the station can actually be received in stereo.
♦ If you would like to switch back to stereo reception, press and hold the
| ST/MO button again for around 2 seconds until ST appears on
the display.
Kitchen timer
The device has a practical kitchen timer with which you can monitor cooking and
baking times, for example. You can set 2 kitchen timers.
Setting and operating the kitchen timer
♦ Turn the −TIMER+ dial left or right to set Timer 1. The display flashes.
NOTE
► Timer 1 can be set in steps of 5 minutes from 5 minutes up to 3 hours
55 minutes. The time is given as "hh:mm".
► If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
♦ Turn the −TIMER+ dial to accept the setting. The
display lights up and
the countdown for Timer 1 starts immediately.
♦ Press the
| Dimmer button to set Timer 2.
The display flashes.
NOTE
► Timer 2 can be set in steps of 1 minute from 1 minute up to 3 hours
59 minutes. If you set the countdown to between 1 minute and 4 minutes,
the time is shown as "mm:ss". If you set the countdown to 5 minutes or
more, the time will be shown as "hh:mm".
► If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
♦ Turn the −TIMER+ dial to accept the setting. The
display lights up and
the countdown for Timer 2 starts immediately.
♦ The countdown for Timer 1 and Timer 2 gives a warning beep at 30, 15,
10 and 5 seconds before expiry to indicate the alarm time.
♦ At the end of the countdown, an alarm signal with rising volume sounds.
Press the −TIMER+ or the −VOLUME+ | ON/OFF
dial to switch off
the alarm. Timer 1 or Timer 2 goes off.
To Next Page
Loading...
Need help?
General
