GB
│
CY
│
9 ■
SNAW 1000 D2
NOTE
► You can only save measurements for which you have also entered a code.
► If make a mistake when entering the code, you can only change the code
before saving by entering it again. It is not possible to change the code
subsequently.
3) Now take the food off the scale and place the next item on the weighing
platform 1.
4) Proceed in the same way to save additional nutritional values. After each
further value stored, the number of the measured value memory display r
is increased by one. The number from the last weighing is displayed.
NOTE
► The memory can store up to 99 measurements. After this, no further meas-
urement can be saved and "M99" flashes on the measured value memory
display r. If you want to save further measurements, you can delete the
saved data by pressing the MC button 5. The M99 display goes out.
► Note that by pressing the MC button 5, all previously stored measured
values are deleted.
► If the total for a saved nutritional or energy value exceeds the maximum
value, the display 3 will show "0-Ld
"
. "ΣM" and the two digits of the last
operation flash to indicate that no further measurements can be stored.
The following maximum values apply:
Weight 99.999 kg / 99:15.9 lb'oz / 999.95 oz
PROT (Proteins) 9999.9 g / 352.73 oz
FAT 9999.9 g / 352.73 oz
CARB (carbohydrates) 9999.9 g / 352.73 oz
BE (bread units) 999.99
KJ (kilojoules) 99999
KCAL (kilocalories) 99999
CHOL (cholesterol) 9999.9 mg / 0.352 oz
Displaying added measured values
You can call up added measured values at any time.
1) Press the MR button 6. The totals of all saved measured values appear on
the display for about 10 seconds.
2) If you do not press any other button for about 10 seconds, the scales will
return to weighing mode.
To Next Page
Loading...
